...
| Note |
|---|
Note that if you have a pre-configured target from ART or Optitrack, you don’t need to do a manual adjustment. You only need to do this if you have a custom target attached to your HMD. The axis alignment might not be correct for pre-defined. Please check that the axis alignment corresponds to what is shown in the SteamVR coordinate system image above. |
The table below shows further possible marker configurations for a Quest Pro HMD.
 |  |
|---|---|
|
Output Settings in DTrack
Create an output channel in the DTrack output settings dialog and point the UDP stream to the IP address of the HMD. In the example below the HMD has the address 192.68.4.27. We’re transmitting data on port 5000. The output port should be set to the same value as defined in your configuration script.
...
Optitrack notes
In order to avoid excessive buffering and data loss, make sure to reduce the amount of data being streamed from Motive. We recommend the streaming settings below. Make sure to set the local interface IP to the IP of the network connection that is being used for communicating with the HMD. It is a common mistake to not set this IP correctly. If the correct IP doesn’t show up, restart Motive.
...