...
Save sensor settings file from sensor
Open IG1Control
Connect to Sensor
Go to menu > Save settings to file
Open the file and you should see the default sensors settings as below:
Change acc/gyroscope settings:
Accelerometer settings:
AR (accelerometer range, g): 2, 4 (default), 8, 16
AOR (accelerometer data output rate, Hz): 3, 7, 15, 31, 62, 100 (defaut), 125, 200, 250, 500, 1000
AF (accelerometer 3-dB bandwidth, Hz): 5, 10 (default), 21, 45, 99, 218, 420
Gyroscope settings:
GR (gyro range, dps): 400 (default), 1000, 2000
Gyroscope I (high precision) settings:
G1OR (gyro data output rate, Hz): 100, 200, 400, 800, 1600, 3200, 6400, 12800 (default)
G1F (gyro low pass filter): value of G1F is calculated as LpfOrder*1000 + LpfFrequency
LpfOrder (low pass filter order): 2, 3, 4 (default)
LpfFrequency (low pass filter cutoff frequency, Hz): 10 (default), 35, 45, 50, 70, 85, 100, 140, 175, 200, 285, 345, 400, 500
Default value: 4*1000 + 10 = 4010
Gyrosocpe II (High range) settings:
G2OR (gyro data output rate, Hz): 3, 7, 15, 31, 62, 100 (default), 125, 200, 250, 500, 1000
G2F (gyro 3-db bandwidth, Hz): 5, 10 (default), 20, 41, 92, 176
Save file and reload the settings file to sensor: menu > load settings from file
Save settings to sensor: menu > save parameters to sensor
Power cycle
...