Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • In case it shows up, please ignore the request for doing a room setup as shown in the following image.

...

  • Open the LPVR control panel (Figure 9) by pointing your At the end of the installation, the LPVR configuration page should be opened automatically. Please be sure to bookmark the location, so that you can access it easily. If it didn’t open, please point your web browser to http://localhost:7118/ to open it. Please make sure to enter the address exactly as shown here. We have tested the UI on Chrome, Edge and Firefox. Users have reported problems on old (pre-Chromium based) Edge browsers. Below we show what the configuration page will look like on a newly installed system.

...

  • You can see live log output from SteamVR at this address: http://localhost:27062/console/index.html. Enter lpvr in the filter box to see only message sent by the LPVR driverImage Added

    The main part of the page contains status visualization and configuration parameters. At the bottom, links to “Expert Mode” (manual configuration by entering configuration parameters in JSON format) and to this documentation are available.

  • Adjust tracking system parameterssettings. Make sure the port number is correctly set in DTrack and that its port is accessible in the network from the computer you are installing this driver on.

...

NOTE 1: When after changing the configuration parameters always make sure you press the Update driver Apply Stettings button to apply the changes.

NOTE 2: If you prefer the z-axis pointing upwards, set the DTrack coordinate system parameter parameters in DTrack to “Normal” and adjust the room directions in the LPVR tracking system configuration to e.g. the following:

X

Y

Z

Left

Backwards

Up

SteamVR always uses Y as up direction, and the DTrack coordinates will be transformed to match this convention on output.

Headset

Adjust HMD tracking parameters. The body ID must be equal to the ID of the tracking marker on the headset in DTrack. Make sure that the rigid body of the tracking marker is aligned in the right way with the HMD. Please see section Adjustment of the HMD rigid body for detail information.

...

System Calibration

Please continue with the calibration instructions.